You can connect to the Lock via its service port when needed. The settings of the Lock don’t have an effect on the functioning of the service port.
On Lock 500/250/210, LAN3 port can be configured as Service port by pressing the reset button for 6 seconds when there is no cable in LAN3 after the Lock has fully booted. When completed, the Internet status LED will blink for three seconds. Reconnect the cable to LAN 3 and the Lock Management Interface can then be accessed by entering http://172.17.17.17 on the address bar of your browser. Assigning the port back to LAN range can be done following the same procedure or by restarting the device.
On Tosibox 175 the LAN port can be configured as Service port by pressing the reset button for 6 seconds when there is no cable in the LAN port after the Lock has fully booted. The status LEDs on the unit will blink when successful.
On Tosibox 600 series (excluding 695) LAN3 port can be configured as Service port by pressing the reset button for 6 seconds when there is no cable in LAN3. When completed, the LAN3 status LED will blink for three seconds. Assigning the port back to LAN range can be done following the same procedure or by restarting the device.
On Tosibox 695/300 series LAN4 port can be configured as Service port by pressing the reset button for 6 seconds when there is no cable in LAN4. When completed, the LAN4 status LED will blink for three seconds. Assigning the port back to LAN range can be done following the same procedure or by restarting the device.
If there is an issue and you cannot connect please try setting a static address on your PC as follows:
IP: 172.17.17.20
Subnet: 255.255.255.248